SYMPTOMS
DEADBATTERY
PROBABLECAUSES SUGGESTEDREMEDIES
Key switch left on
Bad battery
Shorted starter solenoid
Turn key off, recharge battery
Replace battery
Replace starter solenoid
ENGINEKNOCKS
Engine idle speed too low
Overloaded engine
Stale or dirty fuel
Adjust engine idle
Avoid overloading engine
Replace fuel with new fuel
ENGINE
BACKFIRES
Fouled sparkplug
Missing or incorrectly installed
air intake restrictor
Throttle cable is defective or out
of adjustment
Replace or clean sparkplug
Replace or correctly install air intake restrictor
Clean and oil or replace cable
ENGINESHUTSDOWN
WHILETURNING,ON
INCLINES,ORON
UNEVENTERRAIN
Low engine oil
Honda oil sensor is bad
Check oil level with unit on level ground
Get Honda low oil sensor changed by authorized
Honda service center
STEERINGFEELSFUNNY/
PULLINGTOONESIDE/
HARDTOSTEER(CALL
NORMALLYFOR4WD)
One side may still be engaged in
4WD with the switch off
One side may still be engaged in
4WD with the switch off
Put unit in reverse and back up straight a few feet
to get the axle to release
Take unit to a service center
BRAKESDONTWORK
WELL/HARDTOPUSH/
NOTRAVELINPEDAL
Brake rotors are dirty
Brake rotors are dirty
Clean rotors with brake cleaner and test. A stiff
pedal is normal for a 4WD unit
Put unit in reverse, back up at low speed and step
hard on the brake
(2WD units have an auto brake adjuster)
ELECTRICAL
SYSTEMNOT
WORKING
Blown or missing fuse
Loose or corroded battery connection
Worn out or defective battery
Replace fuse
Clean and tighten connections
Replace battery
Defective ignition switch
Bad connection in wire harness
Replace ignition switch
Replace or replace wire harness
BATTERY
WONTCHARGE
Loose or corroded battery connection
Defective voltage regulator
Dead battery cell
Clean and tighten connections
Bad magnet on engine Contact local Honda service center
Contact local service center
Turn key on and pull rope to start engine.
Replace battery as soon as possible
Worn out or defective battery
Turn key on and pull rope to start engine.
Replace battery as soon as possible
4WD
2WD
BELTSLIPPING/
WILLNOTPULL
UPHILL
Too much weight
The belt is wet
Torque converter pulleys are dirty
Lighten load
Dry the belt
Belt may have stretched or have a
low spot causing slipping
Replace the belt
Clean the torque converter
19
SECTION 6
troubleshooting
Kommentare zu diesen Handbüchern